Our knowledgebase contains all the information you need to know about all things SmartBench
If you have an SC0 - SC2 spindle you can run the spindle in manual mode which removes the chance of any communication issues through the speed control cable:
To test this disconnect the data cable from both ends, this is the smaller of the two cables exiting the top of the spindle.
Make sure the data cable is DIS-CONNECTED.
This means that the speed is controlled by the thumbwheel on the top of the spindle. The number 1-6 indicates the requested speed. Reference speeds are available on the side of the spindle or below.
Ensuring your spindle is clamped navigate to the CAD/CAM App then to the Move section. To test run your spindle press the “Spindle on” button (shown below in the red box)
Manual mode reference settings:
Elliot. is the author of this solution
Glad we could be helpful. Thanks for the feedback.
Sorry we couldn't be helpful. Your feedback will help us improve this article.