Z-Head + Console

Please ensure the grey piece is located to support the laser. Be careful not to crush the console cable.

Step 1 - How to protect the laser

Step 2 - Side protection and console

Step 3 - Top foam and seal box

Upper + Lower Beam

• Please ensure the four longer foam pieces are separated, the side two are smaller.

• The foam between the upper + lower beam sits on the plastic window side. 

• The drag chains need to be located inside the upper beam. 

• Locate the four L-shaped pieces along the lower beam to protect the wheel plates and the connectors.

Step 1 - Initial foam on ends and bottom

Step 2 - Foam between the beams

Step 3 - Drag chain and beam end supports

Step 4 - L-Shaped Foam

Step 5 - Top piece on and seal box.

Any further questions please contact customer support via a support ticket